Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING
Service
WARNING
cause a serious hazard . We recommend that all tool service be performed by a SKIL Factory
Service Center or Authorized SKIL Service Station.
WARNING
Service Station before using the drain cleaner.
General Maintenance
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced. Please contact customer service an
authorized service center for assistance.
Cleaning
The tool should be cleaned after each use to prevent contamination and residue build up. And
it may be cleaned most effectively with compressed dry air.
WARNING
foreign matter. Do not attempt to clean by inserting pointed objected through openings.
WARNING
ammonia and household detergents that contain ammonia.
Draining the drum:
a. Remove the battery pack from the tool.
b. Use a coin to loosen and remove the draining hole plug on the drum.
c. Rotate the drum of the tool so that the draining hole is facing down, allow any liquid inside
the drum to pour down a drain or into a container approved for liquid waste.
d. Reattach the draining hole plug to the rear drum using a coin.
WARNING
the product.
Cleaning the Cable
The cable should be thoroughly flushed with water after every use to prevent damaging effects
of sediment and drain cleaning compounds.
WARNING
After washing, dry the cable completely. Then, wipe cable with an oiled rag before returning it
to the drum.
Storage
Store the tool indoors or well covered in rainy weather in a place that is inaccessible to
children and people unfamiliar with drain cleaners. Keep away from corrosive agents.
To avoid serious personal injury, always remove the battery pack
from the light when cleaning or performing any maintenance.
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
To avoid injury, never change the cable by yourself .
worn or damaged cable replaced by an Authorized SKIL Service Center or
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage .
Always wear safety goggles when cleaning with compressed air .
Ventilation openings and switch levers must be kept clean and free of
Certain cleaning agents and solvents damage plastic parts. Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
The draining hole plug shall not be lost. Operation of the product without it
may result in injury to the user. Be sure to secure it in place before using
Wear leather gloves.
Always have the
15
Publicidad
