Publicidad
Idiomas disponibles
Idiomas disponibles
EXTENSION WINGS
For the 36-5052 T2 and 36-5152 T2
Hardware Bag "D"
1.
Attach both extension wings
four 5/16-18 x 1-1/8 inch Flat Countersunk Hex Screws
and 5/16-18 Hex Flange Nuts
HP15
2.
Attach both extension wings
four 5/16-18 x 7/8 Hex Screws w/ Split Lock Washers
and 5/16-18 Hex Flange Nuts
3.
Attach both right extension wings
Rear rails using four 5/16-18 x 1-1/8 inch Flat Countersunk
Hex Screw
and 5/16-18 Hex Flange Nuts
HP15
4.
Attach the extension wings
5/16-18 x 7/8 inch Hex Head Screws with Split Lock
Washers
for each wing. See Figure 10.
HP7
NOTE: Use a ruler to make sure the top edges of the wings are
flush with the top of the tabletop. See Figure 10.
NOTE: There are four 5/16-18 Set Screws
extension wings for the 36-5100 T2. Two Set Screws for each cast
iron Extension Wing. The set screws are used to adjust the level.
See Figure 9.
WOOD EXTENSION TABLE
For the 36-5052 T2 and 36-5152 T2
Hardware Bag "E"
1.
Lay the Wood Table Extension
bench.
2.
Position table legs
PC21
vertical wall of the angle plate on the leg should be against
the end wood wall of the table.
3.
Fasten the legs to the table board with eight 8 16 x 3/4
Round Head Phillips Screw
4.
Feed four 10 32 x 34.5mm Round Head Phillips Screw
with four 7/32 x 1/2 Flat Washers
through the drilled holes from the outside, then
HP11
assemble the nuts onto the screws and tighten.
ASSEMBLY
[3] to the front rail using
PC10
.
HP14
[3] to the rear rail using
PC10
.
HP14
[3], to the Front and
PC10
.
HP14
[3] to the table using three
PC10
for the cast iron
HP24
upside down on floor or
PC20
in corner as shown in Figure 11 the
.
HP12
and 10-32 Hex Nut
HP10
PC10
RULER
HP7
3
LEFT EXTENSION
LEFT EXTENSION
WING
WING
PC21
HP9
20
PC10
3
RIGHT EXTENSION
RIGHT EXTENSION
WING
WING
Figure 10
HP9
HP12
Figure 11
PC20
Publicidad
