Delta 36-5000 T2 Manual De Instrucciones página 29

ALIGNING FENCE PARALLEL TO
MITER SLOT
1.
Move rip fence
PC4
and secure to the guide tube by lowering the fence
clamping lever.
2.
If the fence face
A
slot , raise the clamping lever and lift the fence and
B
place it on the saw table.
3.
Adjust one or both of the set screws
4.
Replace fence on guide tube and verify the fence is parallel
to the miter slot. If fence is closer to parallel, turn the set
screw in the same direction but a little less. If the fence is
further out of parallel, turn the set screw in the opposite
direction.
ALIGNING FENCE
PERPENDICULAR TO THE TABLE
1.
Move fence over the cast iron table and secure to the guide
tube by lowering the fence clamping lever.
2.
Use a square to check that the fence face is perpendicular
to the table.
3.
If the fence face is not perpendicular to the table, release
the clamping lever and slightly adjust one of the slotted set
screws , Figure 32, until the fence face is perpendicular
A
to the table.
4.
Secure the fence to the guide tube to insure the fence
remains perpendicular. If not, repeat steps 1 through 3.
DUST COLLECTION
1.
Connect a shop vacuum or dust collection hose to dust port
on back of saw for best dust collection.
MAKING ADJUSTMENTS
adjacent to right miter gauge slot
, Figure 31, is not parallel to the miter
1/4 turn or less.
C
B
C
B
29
A
Figure 31
A
Figure 32
Figure 33