Publicidad
Idiomas disponibles
Idiomas disponibles
RIP CUTS
Rip cutting is performed predominantly in a parallel direction with
the grain of the wood.
Make sure blade is parallel to miter gauge slot prior to cutting.
Instructions for adjustment on page 33.
1.
Remove miter gauge.
2.
Make sure bevel angle is set to 0°.
3.
Set blade to correct height for workpiece.
4.
Install rip fence and lock it down parallel with and at
desired distance from blade.
5.
KEEP fingers at least 6 inches from the blade at all times.
When hands and fingers CANNOT be a safe distance
from the blade, select a larger workpiece, or use a push
stick and other cutting aids, as needed, to control the
workpiece.
6.
Make sure the workpiece is clear of the blade (at least 1
inch or 25mm away) before starting the saw.
7.
Turn saw on.
8.
Stand alongside the workpiece on the same side of the
blade as the fence.
9.
Hold the workpiece flat on the table and against the fence
. The workpiece MUST have a straight edge against
A
the fence and MUST NOT be warped, twisted or bowed.
See proper hand position in Figure 47.
10.
Let blade build up to full speed before moving workpiece
into the blade.
11.
Both hands can be used while starting the cut as long as
hands remain 6 inches from the blade.
12.
KEEP the workpiece against the table and fence and
slowly feed the workpiece rearward all the way past the
saw blade. DO NOT overload the motor by forcing the
workpiece into the blade.
13.
Use the push stick and any other cutting aids, as needed,
to hold the workpiece against the table and fence, and
push the workpiece past the blade. A push stick is included
with this saw, and instructions are included to make
additional push sticks and other cutting aids.
14.
DO NOT push or hold onto the free or cut-off side of the
workpiece.
15.
Continue pushing the workpiece until it is clear of the
blade. DO NOT overload the motor by forcing the
workpiece into the blade.
16.
When cut is complete, turn saw off. Wait for blade to come
to a complete stop before removing workpiece from table.
BEVEL RIPPING
Bevel ripping is the same as ripping except the bevel angle is set
to an angle other than 0°. When making a bevel rip cut, place the
fence on the right side of the blade so that the blade is tilted away
from the fence and hands.
•
Avoid bevel cuts with a majority of material on the left side of
the blade.
MAKING CUTS
37
A
Figure 47
Figure 48
45º
Publicidad
