Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION (SITE, TYPE OF SUPPORT, NECESSARY SPACE)
•
Install the HP outdoors at more than 2 meters from the pool.
•
Place the HP on the provided vibration absorbers on a surface that is stable, solid (able to bear the weight of the device) and level (prepare a concrete base if
necessary).
•
Maintain 1 m (30 cm minimum) of open space in front of the vertical air intake grids (behind and on the side of the HP) and 3 m at the outlet of the fan (in front) of
open space without any obstacles.
•
Prepare sufficient space around the HP for maintenance operations.
•
Prepare a water evacuation system close to the HP to protect the installation zone.
•
Keep the HP out of the reach of children, insofar as possible.
The HP should never be installed:
•
In an area covered by sprinkling systems, or subject to spray or running water or mud (close to a road, take into account the effects of wind),
•
Under a tree,
•
Close to a source of heat or of flammable gas,
•
In an area where it would be exposed to oil, flammable gases, corrosive products, and compounds containing sulphur,
•
Close to equipment operating at high frequencies,
•
In a place where snow is likely to accumulate,
•
In a place where it could be flooded by the condensates produced by the device as it operates,
•
On a surface that could transfer the vibrations to the house.
Advice: dampen the possible noise nuisance caused by your HP.
•
Do not install it close to or underneath a window.
•
Do not direct the outlet of the fan towards your neighbors' property.
•
Do not direct the fan outlet (cold air) towards the swimming pool.
•
Install it in an open area (sound waves bounce off surfaces).
•
Install a sound barrier around the HP, making sure to maintain the required distances.
•
Install 50 cm of PVC piping at the water inlet and outlet of the HP.
The HP must be installed and maintained on a fixed and solid basis, with the skids placed under the feet.
•
For concrete, use adapted ø 8 mm lag screws fitted with washers to prevent any loosening.
•
For wood, use adapted ø 8 mm hexagon head screws fitted with locking washers to prevent any loosening
3m mini
- 20 -
The Ottimo HP has four feet and a condensate ex-
traction nozzle included with the product.
the condensate extraction nozzle and the four feet
must be attached before installing the machine,
using the described methode in the figure above.
Publicidad
