Garland XTRIM KEEPER40V 355 R Manual De Instrucciones página 32

English
3
Pull each thread until about 12 cm has been expelled.
Install the bottom cover.
6.2.4. ASSEMBLY OF PROTEGE PLANTS
6.3. START UP
6.3.1. VERIFICATION POINTS BEFORE START-UP
The supply voltage and current must comply with the
information on the nameplate. Before starting work,
always check that the machine is working correctly
and its operation is safe.
Do not use this machine if it is damaged or improperly
regulated.
Use this machine for the purpose for which it was
designed. Any other use can be dangerous for the
user, for the machine and for people, animals and
things that may be around.
Verify:
- The machine completely and look for loose parts
(screws, nuts, etc.) and damages.
3
- That the protector is correctly fixed to the machine.
- That the head is not damaged.
Tighten, repair or replace everything necessary before
using the machine.
6.3.2. ASSEMBLY OF THE HANDLE
32/104