Descargar Imprimir esta página

Garland XTRIM KEEPER40V 355 R Manual De Instrucciones página 34

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

English
6.3.7. CHECKPOINTS AFTER TURNING THE
MACHINE ON
It is important to pay attention to the possible loose
parts and/or the temperature of the machine. If you
detect anything unusual in the machine, immediately
stop and check it carefully. In case of any malfunction
or problem take the machine to be repaired.
Never continue to use the machine if the operation
does not seem appropriate. Do not use the machine if
it is damaged or incorrectly adjusted.
6.4. BATTERY CHARGE
The supply voltage and current must comply with
the information on the nameplate of the charger.
Before using the battery for the first time charge it for
at least 1 hour for the 4 Ah and 40 min for the 2 Ah
To charge the battery plug the charger into the
network, the led will light red. Place the battery in the
charger, the led will light green and start blinking. The
charger LED will change from flashing green to green
when the battery is fully charged. When the battery is
charged, remove it from the charger. If you leave the
battery in the charger and the charger is charged, the
charger will automatically turn off after 2 hours and
the led will turn green.
If you insert the battery in the charger and the LED
starts flashing red, it means that your battery is
damaged or that the battery does not correspond to
this charger.
Important! If you fully charge your battery,
disconnect it from the charger and reconnect it without
using it, the LED may start flashing red (broken battery
signal) when it detects that the battery does not accept
a charge. In this case the flashing red LED does not
mean that the battery is damaged.
Recharge the battery when you notice that the power
of your machine decreases. Avoid using the machine
until the battery is fully discharged. To check the status
of your battery, press the black button and the green
LED will light indicating your battery's charge
Battery charge indicators
Black button
Notes:
- The battery will require 2 or 3 complete cycles
of charge discharge until it reaches its maximum
capacity of energy storage.
- This battery has no memory effect so it is not
necessary to discharge it completely before
reloading it.
- If you are not going to use the battery for a long
period of time, charge it to the maximum, store
it in an appropriate place and recharge it every 30
days.
Follow the following tips to ensure that the
Your battery's charge capacity remains the same
maximum possible time:
- Avoid completely discharging the battery. The
life of the battery will be longer if you recharge
the battery when you notice that the power
of your machine decreases and do not let it run out
completely.
- Always recharge the battery after using the
machine. Do not store the battery discharged or at
half load.
- Always recharge the battery inside your house
and garage to preserve the battery and charger
from moisture and inclement weather.
34/104

Publicidad

loading