W-Dmx™ Status - Cameo H2 D Manual De Usuario

MAIN SCREEN STAND-ALONE MODE
Mode Static is shown on the display.
MAIN SCREEN 1 SLAVE MODE
Mode Slave is shown on the display.
MAIN SCREEN 2 W-DMX STATUS
The W-DMX status is shown on the display. Briefly press ENTER and DOWN at the same time to switch between the two main displays.
The main display 1 is automatically displayed again after approx. one minute.
W-DMX™
To pair the W-DMX receiver with a W-DMX-enabled transmitter, W-DMX (W-DMX On) must be switched on in the receiver menu under
Wireless Settings and Reset must be selected in the same menu option (select Reset and press ENTER to confirm). The receiver is now
ready to pair and waits for a transmitter to request pairing. Start pairing by selecting Link in the transmitter menu and then confirm your
selection. Pairing will then be carried out automatically. These same steps can be used to pair several receivers to a transmitter at the same
time or in succession. A W-DMX connection will remain connected until it is severed by selecting Reset in the receiver menu or Unlink in
the transmitter menu, regardless of whether a device is temporarily disconnected from the power supply.
W-DMX™ STATUS
W-DMX W-DMX
deactivated activated,
not paired
CONFIGURING DMX MODE
You can access the main menu by pressing MENU. Using UP and DOWN, now select the
DMX Address menu option and press ENTER to confirm your selection. You can now set the DMX start address as desired using UP and
DOWN. Select ENTER to confirm your entry.
W-DMX W-DMX
activated activated
and and
paired, paired,
Transmitter no DMX signal
switched off DMX signal
or out of
range
RF SIGNAL STRENGTH
W-DMX
activated
and
paired,
present
7