AERMEC RePuro 100 Manual De Uso página 27

4. USER INTERFACE
4.1. CONTROL PANEL DISPLAY
The RePuro units are controlled by the user through a control panel. This panel has a large display and simplified use through clear identifying icons.
The icons represented on the display are detailed in the following schematic:
1
2
3
4
4.2. CONTROL KEYS OF THE WALL MOUNTED CONTROLLER
The control panel of the RePuro unit has four touch keys for the control of all the functions and settings. The control panel keys are the following:
A B
8 9 10
7 6 5
C D
Index
These numbers could show:
- Ambient temperature
- Temperature setpoint (heating or cooling)
1
- Operating time (Cleaning Time)
- Password to access operating parameters
- String to identify the operating parameter
If this icon is present it indicates that the working setpoint (heat-
2
ing or cooling) is in modification mode
If this icon is present it indicates the operating mode:
3
- Icon on = AUTOMATIC mode active
- Icon off = MANUAL mode active
This icons shows the fan speed setting for the fans PO1 (supply
4
fan) and PO2 (extract fan)
This symbol can indicate:
• SUMMER operation (fixed icon)
5
• SUMMER operation + freecooling
(icon flashing)
5
This icon indicates the enabling of any heaters for pre
heating :
(3)
6
- Icon on = enabled
- Icon off = disabled
This symbol can indicate:
• WINTER operation (fixed icon)
7
• WINTER operation + freecooling
(fixed icon plus icon
5
• Anti-freeze function active (icon flashing)
8
This icon shows that the unit is controlled by a supervisory system
This symbol shows the status of the unit:
9
- Icon on = RePuro OFF
- Icon off = RePuro ON
This icon shows the status of any heaters for pre or post heating:
10
- Icon on = at least one heater on
- Icon off = no heater on
NOTE:
(1) free cooling function is not available on sizes 100 and 170;
Pre-heating resistance (R version) is not available on sizes 100 and 170;
(2)
Resistance-heater plenum accessory available on PLS or PLSM, version E;
(3)
Key
A
Switch heat recovery unit on and off
- Select operating mode
- Enable heaters
B
- Select and confirm parameters
- Confirm parameter value
- Move to previous parameter
C
- Decrease the value of the parameter
- Move to next parameter
D
- Increase the value of the parameter
Description
(1)
or post
(2)
flashing)
Description
1811 - 4238020_01
27