Comet 8 - 18 Manual De Instrucciones página 27

WARNING
• This part of the manual is intended for the
WARNING
• Wear gloves and safety goggles when unpacking to protect your hands and eyes.
• Packaging materials (plastic bags, clamps etc.) can be dangerous: never leave them within the reach of
children.
• Dispose of packaging materials properly according to the current regulations where the pump is installed.
Plastic bags and other plastic materials are not eco-friendly.
• After unpacking the pump, check it is not damaged and make sure its identification plate is attached to the
case.
In case of doubt, do not use the pump and contact your dealer.
Make sure that pump supplied also has the following:
• operating and maintenance manual;
• guarantee certificate.
Contact your dealer in case of doubt.
WARNING
• These instructions and the guarantee certificate must always accompany the pump and be handed over to
the end user of the pump.
WARNING
• It is the responsibility of the
The specifications of the motor (electric motor or combustion engine) to be connected to the pump must
be suitable for the performance and the specifications of the pump (power, speed of rotation, flanges, etc.)
listed in the technical documents provided by the Manufacturer.
• The design of the machine with the pump must safeguard compliance with the safety standards required by
European Directives. This conformity is guaranteed by the
issued by the Manufacturer of the machine with the pump.
• The pump must be installed and operated horizontally.
• The pump must be secured in a stable manner.
• As this is a positive-displacement pump, it must always be fitted with a pressure control/limit valve.
CAUTION
• Pump applications must comply with the principals of good mechanics. The Manufacturer's Service
Department can provide any additional information for installers.
CONNECTION TO AN ELECTRIC MOTOR (8 AND 18 ONLY)
These pumps can be connected directly (no reduction unit necessary) to a MEC 71, 4-pole (50/60 Hz)
electric motor (Ø 14 mm drive shaft) with a B14 type flange or a NEMA 56, 4-pole (50/60 Hz) electric
PART TWO
(FOR THE SKILLED TECHNICIAN ONLY)
SKILLED TECHNICIAN
UNPACKING
STANDARD EQUIPMENT
INSTALLATION
SKILLED TECHNICIAN
APPLICATIONS
only and not for the pump operator.
to follow the instructions provided in this manual.
mark and by the Declaration of Conformity
EN
27