Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Connecting the guide track
The guide track
is used to make straight cuts.
21
To connect 2 guide tracks, slide the fastener
into the notch of the guide tracks. Tighten the set
screw
with the included hex key.
22
23
Note: guide tracks
21
(black rubber lip). The chipping guard must be ad-
justed before making the first cut. Place the guide
track on a work piece. Set to a cutting depth of ap-
prox. 10 mm. Switch on the plunge saw and steadily
guide it in the direction of the cut, pushing slightly.
Eccentric screws
The eccentric screws
10
accuracy of fit of the saw table
Tighten the eccentric screws
clearance between the plunge saw and the
fence
.
21
36 GB/MT
4
22
feature a chipping guard
10
are intended for adjusting the
to the fence
9
to minimize the
10
Cutting (without guide track)
Perpendicular cuts
Hold the tool by the handles
both hands.
Switch on the device as described under "Swit-
9
ching on and off".
9 a
Start the tool down on the work piece at the
front of the saw stand
Move the motor downward and cut, applying
steady forward pressure, never backwards.
Mitre cuts to 45 °
Set the cutting angle and cut line as specified.
23
Hold the tool by the handles
both hands.
Switch on the device as described under "Swit-
ching on and off". Start the tool down on the
work piece at the front of the saw stand
Move the motor downward and cut, applying
steady forward pressure, never backwards.
Plunge cuts
When "plunge cutting" at angles other than a
right angle, secure the base plate of the saw
from sliding sideways. Lateral movement can
cause the saw blade to jam, hence kickback.
Set the desired plunge depth as specified above.
Start the tool down on the work piece.
Prevent kickback and place the back edge
against a stopper (similar to Figure D referenced
in section "Plunge saws with fence").
Switch on the device as described under "Swit-
ching on and off".
Hold the tool by the handles,
both hands and swivel it.
Note: The cutting width marker
.
21
the guard indicates the front and back cutting points
of a 165 mm saw blade at maximum cutting depth.
This applies to plunge cuts with fence
plunge cuts without fence
and
with
3
15
.
9
and
with
3
15
.
9
and
, with
3
15
on the side of
16
as well as
21
.
21
Publicidad
