Publicidad
Idiomas disponibles
Idiomas disponibles
10. POURING FLUID INTO THE TANK
Model series SODA AS-45 Green Line new, SODA AS-110 Green Line new
Fill the plastic tank with clean water without any chemical treatment right up the mark MAX.
WARNING: Before starting, fill the tank with clean water up to the mark MAX. Do not use
any chemicals, as this could damage the cooling system. An ecological antifreeze mixture
based on propylene glycol can be used for cooling to temperatures below freezing.
WARNING: Check the connection of the pump outlet, if it is not connected, water will
spray from the pump outlet after switching on the device.
WARNING: After connecting the cooling coil the water level may drop in the plastic tank,
so check again and add water if necessary.
11. TEMPERATURE AND ADJUSTMENT
The temperature of the cooled beverage is controlled by a mechanical thermostat in
temperature range of 2 °C to 8 °C. The thermostat has a numerical scale of 1-7.
12. HOW TO WORK WITH SPEED FITTINGS
12.1 Speed Fitting Installation:
Grasp the speed fitting and insert the hose all the way inside the speed fitting body (ca. 20 mm).
The end of the hose must be straight so that it plugs fully into the coupling. If the hose will not go
in, moisten the end of the hose.
12.2 Speed Fitting Removal:
Hold the grey ring tight against the body of the speed fitting and pull out the hose.
WARNING: If you do not hold the grey ring but pull at the hose, the speed fitting will cut
even deeper into the hose.
WARNING: Hoses must not be pressurised during removal.
:
(see Fig. 10.)
:
(see Fig. 11.)
:
(see Fig. 12.)
EN
21
Publicidad
