LINDR SODA PYGMY Green Line new Instrucciones De Uso página 23

17. PUTTING INTO OPERATION:
1. Connect the device to CO2 supply.
2. Connect the device to water supply.
3. Check that all the joints and connections are sufficiently tight.
4. For SODA AS-45 Green Line new and SODA AS-110 Green Line new, fill the cooling tank with
clean water up to the mark MAX.
5. Connect the device to the power mains.
6. Switch on the device with the main switch (use thermostat for the SODA PYGMY Green Line
new model).
7. You can use the tap to dispense a drink.
WARNING: If you discover a leak, turn off the device. Fix any leaks found on the tubing. If
a leak is found inside the device or you are unsure how to proceed, contact a service centre.
18. RECOMMENDED ACCESSORIES:
• AquaStop
• Water filter ( is required for the correct operation of the device)
• Water pressure reducer (is required for the correct operation of the device)
• Tubes and fittings
NOTE: The recommended accessories are not included. The supplier is not liable for
damages caused by not using this recommended accessory.
Max. inlet water temperature (beverages) 25 °C.
EN
23