Publicidad
Idiomas disponibles
Idiomas disponibles
en Installation instructions
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be heat-resistant up to
90 °C, and adjacent unit fronts up to
70 °C.
¡ Do not install the appliance behind a decor-
ative panel or unit door. There is a risk of
overheating.
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ The mains socket for the appliance must
be located outside of the area where the
appliance is installed.
¡ Always earth electrical appliances.
¡ Wear protective gloves so that you do not
cut yourself. Parts that are accessible dur-
ing installation may have sharp edges.
¡ Dimensions of the figures in mm.
19.4 Installing below a hob
If the appliance is installed below a hob, the following
minimum dimensions must be adhered to (including
substructure, if applicable).
Hob type
Induction hob
Full-surface induction hob
Gas hob
Electric hob
52
19.2 Appliance dimensions
You will find the dimensions of the appliance here
19.3 Installation below a worktop
Observe the installation dimensions and the safety
clearances when installing below a worktop.
To ventilate the appliance, the intermediate floor must
have a ventilation cut-out.
The minimum worktop thickness
the required minimum clearance
raised in mm
37
58
27
27
flush in mm
38
58
38
30
is determined by
.
in mm
5
5
5
2
Publicidad
