Publicidad
Idiomas disponibles
Idiomas disponibles
The green pilot
light
on
the
switch turns on
but there is no
image on the
screen
Image
is
in
black
and
white
Image without
real colors
Blurred Image
Image is too
bright.
Image is too
INMANUUML023 USER M./M.USO PROCAM HD BASIC V.2022.10 ENG/ESP US
The fuse is
damaged or
burnt.
Poor connection
Video Input
processor of the
monitor does not
register the
camera correctly
Monitor off.
Monitor
disconnected.
Monitor in wrong
video mode.
The camera is
not connected.
Videocamera
incorrectly
connected.
Camera
is
defective.
Incorrect
White
Balance.
Lack
of
focus
adjustment of the
external
optical
system.
Misadjusted
monitor.
Not enough light.
Replace the fuse.
Verify that both ends of the cord are completely
plugged to the connector.
Turn off the monitor, and turn it on again after 10
seconds.
Turn off the PROCAM HD console and turn it on
again after 10 seconds.
Change the video output at the PROCAM HD
console
If the monitor has more than one video input,
change the connection to another input.
Turn the monitor on.
Plug the monitor to the PROCAM HD console
through the provided cord.
Set the monitor in HDMI video input.
Connect the camera connector to the front panel
of the console.
Check if the videocamera connector is correctly
and completely connected to the frontal panel of
the PROCAM HD console.
Please contact to the nearest Technical Service.
Adjust White Balance.
Perform the focus adjustment of the optical
system (endocoupler).
Check if the videocamera has the adapter ring (if
corresponds).
Calibrate properly the image levels of the monitor
Increase the levels of intensity of illumination of
USER MANUAL – PROCAM HD II
Página 13 de 30
Publicidad
