Publicidad
Idiomas disponibles
Idiomas disponibles
YOU WILL NEED THE FOLLOWING
TOOLS FOR ASSEMBLY
The tools are not part of the scope of delivery.
1
6mm
1. Hex key 6mm for models woth stem
SETTING THE SEAT POSITION
Adjust the seating position so that the child is seated
upright and a good overview is ensured. The handlebar,
hand brake lever and bell must be easy for the child to
reach.
To set the seat position you will need the following tools.
(The tools are not part of the scope of delivery.)
• Hex key 5 mm and 4 mm
Setting the height of the saddle: The saddle can be
pulled out after releasing the saddle clamp with the
aid of a hex key 4mm / 5mm.
GB
2
5mm
4mm
2. Hex key 4 mm and 5 mm
Set the saddle so that at least the toes, preferably the
ball of the foot, reach the ground in order to ensure
balance can be achieved when at a standstill.
3
Crosstip screwdriver
Screwdriver T20
3. 15 mm spanner, Crosstip and Screwdriver T20
The minimum insertion depth of the seat post is
indicated by a marking. The seat post must not be
pulled out of the seat tube beyond this marking. Then
tighten the saddle clamp again (torque 5-8 Nm).
17
Publicidad
