Puky KINDER-STRASSENFAHRRAD Manual De Instrucciones página 22

INSTALLATION OF GEAR HUB
(ONLY FOR 3-GEAR MODELS)
To assemble the gear hub you will need the following
tools. (The tools are not part of the scope of delivery.)
• 5 mm Hex key
1
SETTING THE GEAR HUB
(ONLY FOR 3-GEAR
MODELS)
To set the gear hub you will need the
following tools. (The tools are not part of
the scope of delivery.)
• 5 mm hex key
If renewed adjustment must be made during the
course of product use, proceed as follows:
Switch the REVOSHIFT lever to 2. Then rotate the
tension adjusting screw (A) in order to align the red
line (D) on the push rod at the end (C) of the hub axis.
22
1. Take the gear stick out of the plastic bag and insert
it as far as it will go, along with the black spring, into
the right side of the rear axle (in driving direction).
A
Tension adjusting screw
B
Push rod
C
End of hub axis
During the setting process, check both yellow lines
from above using the window. Rotate the crank and
3 to 1 and then back to 3. Repeat this process two
or three times and check to make sure that the
gears are changed. Switch the REVOSHIFT lever
from 1 to 2 again and make sure that the red line on
D
E
F
A
C
D
B
switch the REVOSHIFT lever from
2
2. Then you can mount the gearbox onto the rear axle
and tighten it with a 5 mm Allen key (3-5 Nm.) No
further settings need to be made to the gearbox.
G
Red line on push rod
Yellow lines
Yellow section of link
the push rod at the end of the hub axis is aligned. If
this is not the case, you must carry out the setting
process again.
After setting switch unit IV secure the tension adjust-
ing screw using the tension adjusting nut (G).
Tension adjusting nut
Torque: 1.5 - 2.5 Nm
G
GB