Publicidad
Idiomas disponibles
Idiomas disponibles
Parameter
Burst Mode
(BURS:MODE)
Gated Burst Mode:
GATed
External Trigger
Timer Burst Mode:
TRIGgered
Internal Trigger
– In gated mode, burst count, burst period, and trigger source are ignored (used for triggered burst only). Manual
triggers ignored; no error generated.
– In gated mode, you can specify polarity of signal on the front panel Ext Trig connector ([SOURce
[1|2]:]BURSt:GATE:POLarity {NORMal|INVerted}). Default is NORMal (true-high).
Front Panel Operations
Press [Burst] >
N Cycle
SCPI Command
[SOURce[1|2]:]BURSt:MODE {TRIGgered|GATed}
Waveform Frequency
You can specify the signal frequency during the burst in triggered and external gated modes. In the triggered mode,
the number of cycles specified by the burst count is output at the waveform frequency. In the external gated mode,
the waveform frequency is output when the external gate signal is true. This differs from the "burst period," which
specifies interval between bursts (triggered mode only).
Waveform frequency: 1 μHz to maximum frequency of the waveform. The default value is 1 kHz. (For an internally
triggered burst waveform, the minimum frequency is 126 μHz.)
130
Burst Count
(BURS:NCYC)
Not Used
Available
Gated or N Cycle
Gated
Burst Period
(BURS:INT:PER)
Not Used
Not Used
.
Burst Phase
TriggerSource
(BURS:PHAS)
(TRIG:SOUR)
Available
Not Used
Available
TIMer
Keysight EDU33210 Series User's Guide
Publicidad
