Publicidad
Idiomas disponibles
Idiomas disponibles
If you need to manually configure any instrument LAN settings, refer to
for information about configuring the LAN settings from the front panel of the instrument.
2. Use the Connection Expert utility of the Keysight IO Libraries Suite to add the instrument and verify a connection. To
add the instrument, you can request the Connection Expert to discover the instrument. If the instrument cannot be
found, add the instrument using its hostname or IP address.
If this does not work, refer to "Troubleshooting Guidelines" in the Keysight Technologies
USB/LAN/GPIB Interfaces Connectivity Guide included with the Keysight IO Libraries Suite.
3. You can now use Interactive IO within the Connection Expert to communicate with your instrument, or you can pro-
gram your instrument using the various programming environments.
Private LAN
A private LAN is a network in which LAN-enabled instruments and computers are directly connected, and not
connected to a site LAN. They are typically small, with no centrally-managed resources. The following figure
illustrates a typical private LAN system.
1. Connect the instrument to the computer using a LAN crossover cable. Alternatively, connect the computer and the
instrument to a standalone hub or switch using regular LAN cables.
Make sure your computer is configured to obtain its address from DHCP and that NetBIOS over TCP/IP
is enabled. Note that if the computer had been connected to a site LAN, it may still retain previous net-
work settings from the site LAN. Wait one minute after disconnecting it from the site LAN before con-
necting it to the private LAN. This allows Windows to sense that it is on a different network and restart
the network configuration.
2. The factory-shipped instrument LAN settings are configured to automatically obtain an IP address from a site net-
work using a DHCP server. You can leave these settings as they are. Most Keysight products and most computers
will automatically choose an IP address using auto-IP if a DHCP server is not present. Each assigns itself an IP
address from the block 169.254.nnn. Note that this may take up to one minute. The front panel LAN indicator will
come on when the LAN port has been configured.
38
Remote Interface Configuration
Keysight EDU33210 Series User's Guide
Publicidad
