Prepare the Instrument for Use
When you receive your instrument, inspect it for any obvious damage that may have occurred during shipment. If
there is damage, notify the shipping carrier and nearest Keysight Sales and Support Office immediately. Refer to
www.keysight.com/find/assist.
Until you have checked out the instrument, save the shipping carton and packing materials in case the unit has to
be returned. Check the list below and verify that you have received these items with your instrument. If anything is
missing, please contact your nearest Keysight Sales and Support Office.
– Quick Start Guide
– AC power cord (for country of destination)
– Certificate of Calibration and Shelf Life Notice
– Keysight Safety Leaflet (9320-6797)
– RoHS Addendum for Arbitrary Waveform Generators (China) (9320-6667)
Documentation and Firmware Revisions
The documentation listed below can be downloaded for free through our website at
www.keysight.com/find/EDU33211A-manual.
– Keysight EDU33210 Series Trueform Arbitrary Waveform Generators Quick Start Guide.
– Keysight EDU33210 Series Trueform Arbitrary Waveform Generators User's Guide. This manual.
– Keysight EDU33210 Series Trueform Arbitrary Waveform Generators Programming Guide.
– Keysight EDU33210 Series Trueform Arbitrary Waveform Generators Service Guide.
For the latest firmware revision and firmware update instruction, go to www.keysight.com/find/EDU33211A-sw.
Recommended Calibration Interval
Keysight Technologies recommends a one-year calibration cycle for this instrument.
Set Up the Instrument
Place the instrument's feet on a flat, smooth horizontal surface. Attach the power cable to the rear panel, then plug
it into main power. Connect the LAN or USB cables as desired, and you may also secure the instrument with a
security lock cable. Finally, turn the instrument on using the front panel [On/Off] button.
The instrument runs a power-on self test and then displays a message about how to obtain help, along with the
current IP address.
Keysight EDU33210 Series User's Guide
23