Domo DO360A Manual De Instrucciones página 54

indication light will turn on. This indicates that the "auto on" function is activated.
Press the arrow buttons to select the time. The max time selection is 24 hours.
After finishing the selection, the time will start to countdown on the display until "auto on" or "auto off",
depending on the selection you made.
You can cancel the timer function at any time by pressing the "on/off" touch.
When the error code E1 or E2 is displayed, the timer selection will be cancelled.
7. SWING touch
To adjust the air direction.
8. FOLLOW ME indicator light
If you set the FOLLOW ME function, this indicator light will illuminate. You can only activate this function
with the remote control.
9. LED display
Will show het temperature and timer selections. When the "dry or "fan" mode is selected, the display will
show the room temperature.
REMOTE CONTROL
· The remote control will only function within 8 m of the air conditioning. Point the
remote in the direction of the air conditioning. The transmission will be confirmed
with a beep signal.
· The air conditioning will not react to the remote if the signal is blocked by curtains,
doors or other materials.
· Make sure the remote doesn't get wet. Don't expose the remote to direct sunlight
or heat.
When the infrared sensor on the appliance is positioned in direct sunlight it is
·
possible that it won't react to the remote control. Make sure there is no direct
sunlight on the infrared sensor.
When other electrical appliances are reacting to the remote control, remove them
·
further away from the air conditioning or contact your supplier.
· Don't use old and new batteries at the same time in the remote control. Don't use
two different types of batteries in the remote control.
· Remove the batteries from the remote, when you won't use it for a longer period of
time. (more than two months)
· Recycle used batteries correctly.
Batteries
The remote control works with 2 AAA (R03/LR3) batteries.
·
· Remove the cover of the batterie compartment, by pressing down on it and sliding
it out of the remote.
· Place the batteries, make sure to follow the indications + and – indicated in the
batterie compartment.
· Place the cover back on the batterie compartment.
NOTE : When removing the batteries all selections will be deleted. When placing
·
new batteries you have to reinstall all the selections.
54
DO360A
ON/OFF SHORT
CUT
TIMER
MODE
ON
TEMP
TIMER
FAN
OFF
FOLLOW
SLEEP SWING LED
ME