+
5. Once the descale solution has been used up,
the descale mode will pause.
6. Rinse and refill the water tank to the MAX
line and empty the waste water container,
then replace both parts on to the machine to
proceed onto the rinse cycle.
7. Press the 2 Cup button to proceed
rinse cycle.
OR
8. When the rinse cycle is complete, the
machine will then go into ready mode.
9. Remove and empty the waste water
container. Rinse the drip tray and water tank
and dry thoroughly before replacing them
MAX
back onto the machine.
CLEANING THE STEAM WAND
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand
with a damp cloth.
• If any of the holes in the tip of the steam
wand become blocked, it may reduce frothing
performance. Manually purge the steam wand
to try and clear the holes.
• If the steam flow is very small and steam wand
is still blocked, unscrew the steam wand tip
using the steam tip cleaning tool, then use
the tool to unblock the holes; cleaning tool
is located in the back of the machine, under
the water tank.
16
5s
Rinse the steam tip and wipe with a clean, dry
cloth. Reassemble the steam wand by screwing
the steam tip back on to the steam wand. Purge
the steam wand after cleaning.
0.5s
&
GROUP HEAD RINSE
• Press '2 Cup' button to flow freshwater
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The filter baskets and portafilter should be
• If the holes in the filter baskets become
Do not put portafilter in dishwasher.
CLEANING THE SHOWER SCREEN
• The group head interior and shower screen
• Periodically run hot water through the
flush cycle.
rinsed under hot water directly after use to
remove all residual coffee oils.
blocked, use the steam wand cleaning tool to
unblock the holes.
WARNING
should be wiped with a damp cloth to remove
any ground coffee particles.
machine with the filter basket and portafilter
in place, without any ground coffee, to rinse
out any residual coffee.