Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: This step is applicable after the necessary wiring
is completed.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tilt the motor assembly to the side
to have more space to tighten shoulder screws.
Fully assemble and tighten second shoulder screw
that was previously removed. (Figure 1a)
2. Securely attach and tighten the canopy screw
cover over the shoulder screws in the hanger
bracket utilizing the keyslot twist-lock feature.
(Figure 1b)
How to Assemble Your Ceiling Fan Blades
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blades when installing, balancing or cleaning the fan.
Do not insert foreign objects in between the rotating
blades.
1. Carefully slide the blade through the slot as shown.
Make sure the notch of blade is fully seated into the
hex socket screw. Securely fasten the eight blades
to the motor housing using the blade plates and
button head screws. (Figure 1)
NOTE: You will find the fan blade set packed in its own
carton and hardware bag in the fan box.
How to Install Your Canopy Housing
Motor Assembly
#10-24
Button Head Screws
(4 each per blade)
HARDWARE USED:
#10-24
Button Head
Screw
BLADE PLATE
11
Canopy
Figure 1a
Canopy Screw
Cover
Figure 1b
Blade Plate
Hex Socket
Screw
Blade
Figure 1
x 32
x 8
Blade
Publicidad
