Publicidad
Idiomas disponibles
Idiomas disponibles
How to Operate Your Ceiling Fan (continued)
9. If you have encountered an issue during the set up
process, you can follow the below procedure to clean
the memory code of your handheld remote:
1)
Turn the wall switch that controls the power to the
fan to the o position, or the breaker that controls the
power to the fan to the o position.
2)
Turn the wall switch that controls the power to the
fan to the on position, or the breaker that controls the
power to the fan to the on position.
3)
Press the "SET" button inside of the battery
compartment of the handheld remote control WITHIN
30 seconds of restoring power to the fan.
4)
Pressing the "SET" button for 2 seconds will
indicate if the fan is programmed to the remote
control in hand.
5)
The fan will beep twice and the light will turn on and
o twice, if there is no light, the fan will beep only –
this indicates that the fan has learned the code of the
handheld you are holding.
6)
Pressing the "SET" button for 5 seconds or more
will start the code clearing process. The fan will beep
twice, the light will turn on and o twice if the fan has
a light.
7)
This will indicate that the fans and handheld
remotes have cleared their memory codes.
8)
Please note in order for the memory codes to be
cleared, you must hold the set button for 5 seconds or
longer.
(Figure 7)
16
SET
Figure 7
Publicidad
