Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan
1. Prior to assembly, set aside and save the hardware
bags packed in the packing. Remove the hanger ball
by loosening the set screw in the hanger ball until the
ball falls freely down the downrod. Remove the pin
from the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstallation in
Step 6. (Figure1)
2.
Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
3. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly.
the black/white, blue, red, gray and yellow wires
and safety cable
through the downrod. (Figure 3)
4. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install the two
set screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully tighten
the nuts using the hex wrench. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod
support is properly installed and the set screws
and nuts are securely tightened. Failure to do
so could result in the fan falling.
Hanger
Ball
Hairpin Clip
Route
Black/White, Blue, Red,
Gray, Yellow wires and
Safety Cable
Set Screws
and Nuts (2)
Downrod
Set Screws
and Nuts (2)
7
Pin
Set screw
Figure 1
Clevis Pin
Figure 2
Downrod Support
Figure 3
Clevis Pin
Hairpin Clip
Figure 4
Publicidad
