Publicidad
Idiomas disponibles
Idiomas disponibles
This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your ceiling fan.
Tools Needed for Assembly
• One Phillips head screwdriver (not supplied)
• One 1/4˝ flat head screwdriver (not supplied)
• One hex wrench (not supplied)
• One stepladder
• One wire stripper
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 10). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
s
e t
p
s
h
a
v
e
b
e
e
n
c
o
m
p
e l
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use with this
product by Fanimation. Substitution of parts or
accessories not designated for use with this product
by Fanimation could result in personal injury or
property damage.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Hanger Bracket
Assembly
Downrod/Hanger Ball
Assembly
Ceiling Canopy
Unpacking Instructions
e t
d
a
n
d
w
l l i
b
e
h
l e
f p
l u
n i
Canopy Screw
Cover Assembly
Motor Coupling
Cover Assembly
Motor Assembly
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
n i f
d
n i
g
y
o
r u
p
a l
c
e
s
h
o
u
d l
• Motor Assembly
• Hanger Bracket Assembly
• Downrod/Hanger Ball
Assembly
• Ceiling Canopy
• Motor Coupling Cover Assembly
• Canopy Screw Cover Assembly
• Light Kit/Glass Assembly
• LED Assembly
• Light Kit Wire Cover
• Steel Cap
• Receiver Unit
• Hand-Held Remote
Light Kit/Glass Assembly
Light Kit Wire Cover
4
Materials
Wire Size A.W.G.
Up to 50 ft.
50 - 100 ft.
y
o
u
b
e
i
t n
r e
u r
p
e t
. d
• Hardware bags:
– Thirty-three #10-24 button head
screws (blade to fan motor hub)
– Two #8-32 Junction box screws,
stainless steel
– Two Flat Washer, stainless steel
– Eight Blade Plates
– Bag Assembly Safety Cable
– Four Wire Connectors
LED Assembly
Steel Cap
14
12
Receiver Unit
Hand-Held Remote
Hardware Bags
Publicidad
