Functions And Features Of The Robot Vacuum Cleaner; Accessories Supplied; Preparing For Use; Insert The Side Brushes - Miele HS17 Instrucciones De Manejo

en
Functions and features of the
robot vacuum cleaner
The robot vacuum cleaner is suitable
for the daily cleaning of short pile car‐
pets, fitted carpets and hard flooring.
Please observe the flooring manu‐
facturer's cleaning and care instruc‐
tions.
The robot vacuum cleaner is fitted with
a camera and various sensors. During
operation, the room plan as well as the
items present in the room are recorded.
The robot vacuum cleaner uses this da‐
ta to create an efficient vacuuming plan
of the surfaces to be vacuumed, which
it can then vacuum autonomously.

Accessories supplied

– Two side brushes
– Two replacement exhaust filters
– Remote control / two batteries
– Base station, including a cleaning
brush
– Power supply unit with connector
– Mains connection cable with plug
– Magnetic strip

Preparing for use

Diagrams 1 - 13 for this section are
at the end of these operating instruc‐
tions.
Insert the side brushes (dia. 01)
 Place the robot vacuum cleaner upsi‐
de down on a level, clean surface.
42
Do not lift the robot vacuum cleaner
by the area around the dust box as it
can come loose.
 Press the two side brushes supplied
firmly but carefully onto the pins pro‐
vided. Ensure that they match up
correctly with the L and R markings.
Remove the protective foil (dia. 02)
 Remove the protective foil from the
base station and from the top of the
robot vacuum cleaner.
Place the batteries in the remote
control (dia. 03)
 Remove the battery compartment co‐
ver.
 Insert the two batteries supplied, ma‐
king sure the polarity is correct.
Switch on the robot vacuum clean‐
er (dia. 04)
 Press the ON switch on the side of
the robot vacuum cleaner.
The rechargeable battery status and the
Auto standard vacuuming mode indica‐
tors will light up in the display.
After approx. 60 seconds the robot vac‐
uum cleaner will switch into standby.
The battery status indicator will contin‐
ue to light up.
The robot vacuum cleaner is reactiva‐
ted by pressing any button on the re‐
mote control or one of the two sensors
in the robot vacuum cleaner display.

Connect the base station

(dia. 05 - 09)
 Open the storage compartment at the
back of the base station (dia. 05).