Fanimation The Camview FPS6225BL Instrucciones De Montaje página 10

How to Assemble the Housing and Blade Holder
1. Remove the four screws in the motor assembly.
Assemble the housing onto the motor assembly using
the four screws and securely tighten. (Figure 1)
2. Assemble the blade arm/holder assembly to
3. Remove the three screws at the base of the motor
assembly. Assemble the trim cover onto the motor
assembly using the three screws and securely tighten.
(Figure 3)
4. Remove the three screws at the very bottom of the
motor assembly. Make sure the plug connectors passes
through the hole in the center of the switch housing
assembly. Assemble the switch housing assembly onto
the motor assembly using the three screws and securely
tighten. (Figure 4)
HARDW ARE USED:
1/4-20 x 10 mm
Phillips Head Screw
10
Housing
Figure 1
Motor Assembly
Blade Arm/
Holder Assembly
Figure 2
x 5
Motor Assembly
Blade Arm/
Holder Assembly
Trim Cover
Figure 3
Motor Assembly
Switch Housing
Assembly
Figure 4