Fanimation The Camview FPS6225BL Instrucciones De Montaje página 11

1. Securely attach the 6-pin connector from motor
assembly to the wiring harness socket within the
switch housing assembly. (Figure 1)
NOTE: Both plug connectors are polarized and will
only fit together one way. Make sure the connectors
are properly aligned before connecting them. Incorrect
connection could cause improper operation and
damage to the product.
2. Remove the one of three screws in the switch
housing assembly. Slightly loosen the remaining two
screws. Assemble the shade assembly to the switch
housing assembly using the two key slots in shade
assembly. Replace the third screw and securely
tighten all three screws. (Figure 2)
3. Connect the 2 single-pin connectors from the socket
plate assembly to the 2 single-pin connectors from the
switch housing assembly. (Figure 3)
4. Remove one of the three screws in the shade
assembly. Slightly loosen the remaining two screws.
Assemble the socket plate assembly to the shade
assembly using the two key slots in socket plate
assembly. Replace the third screw and securely
tighten all three screws. (Figure 4)
How to Assemble the Light Kit and Blades
Switch Housing
Assembly
Switch Housing
Assembly
Switch Housing
Assembly
11
Figure 1
Shade Assembly
Figure 2
Socket Plate
Assembly
Figure 3
Shade
Assembly
Socket Plate
Assembly
Figure 4