Transport And Storage; Overview Of The Product - Hilti DSH 700 Manual Del Usuario

▶ The cutting disc and flange or any other accessory must fit the arbor of the product exactly. Cutting
discs or accessories with arbor holes that do not match the mounting hardware of the product will run
out of balance, vibrate excessively and may cause loss of control.
▶ Always use an undamaged clamping flange of the correct diameter which fits the cutting disc used.
The correctly fitting clamping flange supports the cutting disc and thus reduces the possibility of disc
breakage.
▶ Guide the product smoothly and do not apply lateral pressure to the cutting disc. Always bring the cutting
disc into contact with the workpiece at right angles. Don't attempt to alter the line of cut by applying
lateral pressure or by bending the cutting disc while cutting is in progress.
▶ Wear protective gloves when changing the cutting disc as the disc will get hot during use.
▶ Abrasive cutting discs which are used for wet cutting must be used up the same day as long periods of
exposure to moisture have a negative effect on the strength of the disc.
▶ Observe the expiry date for resin-bonded cutting discs and don't use the discs after this date.

2.1.6 Transport and storage

▶ Switch the product off before transporting it.
▶ Remove the cutting disc from the product after use. The cutting disc may suffer damage during transport
with the disc fitted.
▶ Handle the cutting disc carefully and store it in accordance with the manufacturer's instructions.
▶ Always store and transport the product in an upright position, not lying on its side.
▶ Do not carry the saw trolley and the product together. Remove the water tank before transporting the
saw trolley.
▶ Do not lift the product and the saw trolley by crane. This is not permissible.
▶ Store the product in a secure place when not in use. Products which are not in use must be stored in a
dry, high place or locked away out of reach of children.
▶ When laying the product down, make sure that it stands securely.
▶ After use, allow the product to cool down before packing it away or placing a cover over it.
▶ Store gasoline and oil in a well-ventilated room in fuel containers that comply with regulations.
3 Description

3.1 Overview of the product

3.1.1 Gasoline-powered cut-off saw
Hood
@
Water supply
;
Forward grip
=
Water valve
%
Starter handle
&
Fuel tank cap
(
Choke lever / half-throttle lock (DSH 700
)
OR DSH 900)
Throttle trigger
+
Rear grip
§
Rating plate
/
Fuel gauge
:
Guide wheels
∙
Cutting disc
$
Clamping screw
£
Clamping flange
|
3.1.2 Saw trolley (accessory)
Grip
@
Throttle trigger
;
Cutting depth adjustment
=
Hold-down device
%
26
1
2
Spark plug connector
¡
Decompression valve
Q
Throttle safety grip
W
Start/stop switch (DSH 700 OR DSH 900)
E
Start/stop switch with integrated half-
E
throttle lock (DSH 700-X OR DSH 900-X)
Primer bulb
R
Water connection
T
Grip for guard adjustment
Z
Blade rotation direction (arrow in front part
U
of guard)
Saw arm
I
Hole for locking pin for changing cutting
O
discs
Pump cover
P
Air filter cover
Ü
Water tank
&
Water connection
(
Axial adjustment
)