Publicidad
Idiomas disponibles
Idiomas disponibles
Intensifiying the sanding pressure does not lead to an
increase of the sanding capacity, but to increased wear of
the machine and the sanding sheet.
For precise on-the-spot sanding of edges, corners and
hard to reach areas, it is also possible to work only with
the tip or an edge of the sanding plate.
When selectively sanding on the spot, the sanding sheet
can heat up considerably. Reduce the orbital stroke rate
and allow the sanding sheet to cool down regularly.
A sanding sheet that has been used for metal should not
be used for other materials.
For sanding, always connect dust extraction.
Scraping
For scraping, select a high oscillation rate. Work on a soft
surface (e.g. wood) at a flat ange, and apply only light
pressure. Otherwise the scraper can cut into the surface.
5. Maintenance and Service Maintenance
and Cleaning
- Before any work on the machine itself, pull the
mains plug.
- l For safe and proper working, always keep the
machine and ventilation slots clean.
Clean Riff application tools (accessory) regularly with a
wire brush. If the machine should fail despite the care
taken in manufacturing and testing procedures, repair
should be carried out by an after-sales service centre for
Stayer.
After-sales Service and Customer Assistance
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts.
Our customer service representatives can answer
your questions concerning possible applications and
adjustment of products and accessories.
Disposal
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Do not dispose of power tools into household waste!
Only for EC countries:
According the European Guideline 2002/96/
EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable
must be collected separately and disposed of
in an environmentally correct manner.
ENGLISH
15
6. EC DECLARATION OF CONFORMITY
The undersigned: STAYER IBERICA, S.A.
Whit address at:
Calle Sierra de Cazorla, 7
Área Empresarial Andalucía - Sector 1
28320 PINTO (MADRID)
Tel.: 902 91 86 81
We declare under our sole responsibility that the product
described under "Technical Data" is in conformity
with
the
following
documents: EN 60745 according to the provisions of the
directives 2004/108/EC, 2006/42/EC.
Ramiro de la Fuente
15
standards
or
standardization
Director General
January 2020
Publicidad
