Publicidad
Comfort Whirlpool Bath
General Operation Information
All bathtubs manufactured by Jacuzzi Luxury Bath are
designed for "fill and drain," which means the bathtub
should be drained after each use and filled with fresh
water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water
continuously like pools or spas.
Close the drain and fill the bathtub until water is at
least 1˝ to 2˝ (25mm to 51mm) above the highest jet
(see water line indicated in the illustration). Do not turn
on the whirlpool system at any time if the jets are not
completely immersed in water. Running the whirlpool
system when there is insufficient water in the bathtub
could result in water spraying outside the bath area.
Running the whirlpool system without water will damage
the recirculating pump.
When exiting the bathtub, the water level will drop
below the jets which could result in water being
sprayed out of the unit. To prevent this, you must
turn unit OFF before exiting bathtub.
Whirlpool Operation
ON: Press the button once to turn the whirlpool jets ON.
OFF: Press the button a second time to turn the
whirlpool jets OFF.
Installation and Operation
All manuals and user guides at all-guides.com
www.jacuzzi.com
Fill to at least 1˝ to 2˝
above highest jet
Figure 18
G
Figure 19
Page 17
Publicidad
