Driving Belts - Nilfisk-Advance Retriever 300B Instrucciones De Uso

Driving Belts

Every 100-150 working hours check the belt tensioning and wear.
Belts 3, 4, 5 (fig 5) are elastic, and the tensioning is automatic. Wheel Drive control belt 2 must be tensioned as follows:
1 Loosen screw 1 and nut 6.
2 Position a lever under drive wheel 7 to tension and tighten screw and nut
Caution !
After this operation check the distance between the roller 3 and wheel 2 (fig 2).
Fig. 5 - Driving Belts
1 Drive Wheel Fastening Screw
2 Driving Belt
3 Main Broom Driving Belt
Abb. 5 - Steuerriemen
1 Befestigungsschraube des antriebsrades
2 Antriebssteuerriemen
3 Steuerriemen der hauptbürste
4 Steuerriemen der seiten- bürste
5 Steuerriemen der bürsten und des antriebes
6 Befestigungsmutter des antriebsrades
7 Antriebsrad
Fig. 5 - Correas de impulsión
1 Tornillo de ajuste de la rueda de impulsión
2 Correa de impulsión
3 Correa de impulsión del cepillo principal
4 Correa de impulsión del cepillo lateral
5 Mecanismo de impulsión y correa de impulsión de la barredora
6 Tuerca de ajuste de la rueda de impulsión
7 Rueda de impulsión
17 - FORM NO. 041323 / RETRIEVER 300B
4 Side Broom Driving Belt
5 Drive Mechanism and Broom Driving Belt
Fig. 5 - Courroies de Commande
1
2
3
4
5
6
7
6 Drive Wheel Fastening Nut
7 Drive Wheel
Vis fixation roue traction
Courroie commande traction
Courroie commande brosse centrale
Courroie commande brosse latérale
Courroie de commande brosse et mécanisme traction
Ecrou fixation roue traction
Roue traction