Panel Filter - Nilfisk-Advance Retriever 300B Instrucciones De Uso

Panel Filter for Dust Control
The dust filter shall filter the dusty air sucked by the fan, and therefore must always be kept in a clean condition.
NOTE: Every time the walk-behind sweeper raises dust while sweeping the filter is dirty and requires shaking / cleaning.
To clean the dust filter operate as follows:
1 Lift both knobs 4 several times attached to the spring loaded hammers 5. The hammers are to strike the filter frame aggressively vibrating
the dust from the filter.
2 About once a month, for a better machine cleaning performance, remove filter 1 and clean it carefully by compressed air, or by a vacuum
cleaner.
For removing the filter operate as follows:
1 Remove the debris hopper.
2 Loosen the two wing nuts 2 and remove the filter holder 3.
3 Pull filter 1 out.
Fig. 6 - Panel Filter
1

Panel Filter

2 Wing Nut
3 Filter Holder
4 Vibrator Knobs
5 Vibrator Hammers
19 - FORM NO. 041323 / RETRIEVER 300B
Abb. 6 - Tafelfilter
1 Tafelfilter
2 Flügelmutter
3 Filterschablone
4 Kugelgriffe des rüttlers
5 Hammer des rüttlers
Fig. 6 - Filtre à Panneau
1 Filtre à panneau
2 Ecrou à papillon
3 Stoppeur pour filtre
4 Pommeaux vibreur
5 Petits marteaux vibreur
Fig. 6 - Filtro
1 Panel del filtro
2 Tuerca mariposa
3 Soporte del filtro
4 Mandos del agitador
5 Martillos del agitador