Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Level gauge
The level gauge (
the side of the grass catcher (
aerodynamic air guidance provided by the
flap also optimises the filling.
Flap open:
grass catcher empty
Flap closed:
grass catcher full
Working with the Lawnmower
Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
When mulch mowing the grass is cut in
one cycle, finely chopped and distributed
on the lawn. The cut grass acts as a natu-
ral fertilizer.
•
Start mowing near the socket and
work away from the socket.
•
Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
•
Run the equipment at a walking pace,
in tracks that are as even as possi-
ble. For gap-free mowing, the tracks
should always overlap by a few centi-
metres.
•
Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
•
On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
72
15) is located on
7). The
•
Clean the equipment after each use,
as described in the chapter on "Clean-
ing, Maintenance and Storage".
Switch off the equipment after
work and in order to transport it,
disconnect the plug and wait until
the blade stops. There is a risk of
injury.
Cleaning/Maintenance
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Wear gloves when handling the
blade
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
General Cleaning and Mainte-
nance Work
Do not hose down the lawnmow-
er with water. This would result
in the danger of an electric
shock and the appliance could
be damaged.
•
Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
•
After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Publicidad
