Publicidad
Idiomas disponibles
Idiomas disponibles
• Before switching on the ma-
chine, always check whether
all screws, nuts, bolts and
other fasteners are tightly se-
cured and that the protection
devices and protective gratings
are in place. Worn or damaged
labels must be replaced. Never
operate the implement if safety
devices (e.g. impact protector,
parts of the cutting facility or
bolts are missing, worn out or
damaged. Check especially
the power cable and starting
lever for damage. To avoid
imbalance, all tools and bolts
must be exchanged as com-
plete sets.
• Never operate the device with
defective guards or covers or
without protection or with da-
maged or worn cables.
• Only use spare parts and
accessories that have been
supplied or recommended by
the manufacturer. The use of
alien parts results in the im-
mediate loss of all guarantee
claims.
• Ensure that all nuts, bolts and
screws are firmly tightened
and that the implement is in a
safe working state.
• Never try to repair the imple-
ment yourself, other than you
have been trained according-
ly. All work that has not been
listed in these Instructions
must only be carried out by
authorised servicing agencies.
• Treat the implement with the
greatest care. Always keep
the tool clean for better and
safer work. Follow the mainte-
nance instructions.
• Never overload the implement.
Always work within the speci-
fied capacity range. Do not
use low-power machines for
heavy-duty work. Do not oper-
ate the implement for purpos-
es for which it is not intended.
• Check the collection unit regu-
larly for wear or loss of function.
• Replace worn or damaged
parts for safety reasons.
• When using the machine with
several prong attachments,
beware that moving one prong
attachment can lead to the
other prong attachments rotat-
ing.
• When setting the machine,
make sure your fingers do not
become caught between the
moving prong attachments
and stationary parts of the ma-
chine.
• Allow the motor to cool down
before parking the machine for
a longer period.
• When servicing the prong at-
tachments, beware that the
prong attachments can be
moved even when the drive is
switched off.
• Replace worn or damaged
parts for safety reasons. Use
only original spare parts and
accessories.
• If the machine is stopped
to service, inspect, store or
replace an accessory part,
switch off the drive, disconnect
the machine from the mains
and make sure that all moving
parts have come to a complete
GB
31
Publicidad
