Publicidad
Idiomas disponibles
Idiomas disponibles
parts to prevent damage to
cables that can lead to cont-
act with live parts.
Residual Risks
There will always be residual ris-
ks even if you operate this electri-
cal tool according to the instruc-
tions. The following hazards may
occur in connection with the type
and design of this electric tool:
a) Cutting injuries
b) Hearing damage if suitable
ear protection is not worn.
c) Health injuries resulting from
the effect of vibration on the
hands and arms in the event
that the device is used over a
longer period of time or is not
used and maintained properly.
Warning! During operation,
this power tool produces
an electromagnetic field.
Under certain circumstan-
ces, this field may negati-
vely affect active or passive
medical implants. In order
to reduce the danger of
serious or fatal injuries, we
recommend that individuals
who wear medical implants
should consult their doctor
and the manufacturer of
the implant before opera-
ting the machine.
Assembling instructions
Prior to any work on the implement
always disconnect the plug from
the power socket!
Ensure during assembly that the
power cable is not squeezed and
that it has sufficient play.
Mounting the grip rods
The quick-release levers (4a/7a)
must rest against the bar in such
a way that tensioning can be carried out
with medium force. The quick-release
lever is turned clockwise to tension. The
quick-release lever is turned anti-clockwi-
se to release.
Mounting the lower bar:
1. Insert the lower bar (6) into the
bar receptors (18) on the device
housing (8).
2. Screw the lower bar (6) to the bar
receptors (18) using two quick-release
levers (7a) and washers (7b).
The smooth side of the washer should
point towards the quick-release lever;
the grooved side should point towards
the device.
3. Fasten the quick-release levers (7a)
by pushing them in the direction of the
lower bar (6).
Mounting the middle bars:
1. Place a middle bar (5) onto the lower
bar (6).
2. Guide the screw (4c) from the inside
through the holes of the lower bar (6)
and middle bar (5).
3. Place the washer (4b) onto the
screw (4c).
The smooth side of the washer should
point towards the quick-release lever;
the grooved side should point towards
the device.
4. Turn the quick-release lever (4a) onto
the screw (4c).
GB
33
Publicidad
