Hilti PM 2-PG Manual De Instrucciones Original página 21

2.6 Careful handling and use of batteries
▶ Remove the batteries from the product if it is to remain unused for a lengthy period of time. Batteries can
corrode and self-discharge during prolonged storage.
▶ Make sure that batteries are inaccessible to children.
▶ Do not mix old and new batteries. Always replace all batteries at the same time. Do not mix batteries of
different makes or types.
▶ Do not use damaged batteries.
▶ Use only the battery type intended for this product. Use of other batteries may create a risk of injury and
fire.
▶ When changing batteries, make sure that polarity is correct. There is a risk of explosion.
▶ Do not allow batteries to overheat and do not expose them to fire. Batteries can explode and release
toxic substances.
▶ Do not attempt to charge non-rechargeable batteries.
▶ Do not solder batteries into the product.
▶ Do not discharge batteries by short-circuiting. Batteries can develop a leak, explode, catch fire and injure
persons.
▶ Do not damage batteries and do not attempt to take batteries apart. Batteries can develop a leak,
explode, catch fire and injure persons.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a self-leveling point laser which allows a single person to carry out vertical alignment
work quickly and accurately. The product features two coincident laser beams (beams that originate from
the same point). All beams have the same range of 30 m (range depends on the brightness of ambient light).
The product is designed for marking plumb points indoors.
Possible applications are: Transferring points marked on the floor to the ceiling.
Do not tamper with or attempt to make alterations to the product.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid risk of injury, use only genuine Hilti accessories and accessory tools.
The product and its ancillary equipment may present hazards when used incorrectly by untrained personnel
or when used not as directed.
3.3 Features
The product is self-leveling within typically approx. 4.0° in all directions. Self-leveling takes only approximately
3 seconds.
When the self-leveling range is exceeded, the laser beam flashes to warn the user.
The product is characterized by its ease of operation and use and its rugged plastic housing. Small and light,
it is easy to transport. In normal operating mode, the product switches off after 1 hour. Sustained operating
mode is possible by switching on, switching off and switching on again within 3 seconds.
*2341493*
1
2341493
Position of rating plate
@
Battery compartment
;
Operating status display and battery charge
=
status display
Laser exit window
%
Magnetic foot
&
Mounting thread
(
Selector switch for ON / OFF and lock / un-
)
lock pendulum
Eye for attaching the retaining strap PMA 92
+
English 15