Hilti PM 2-PG Manual De Instrucciones Original página 25

• Have the product checked by Hilti Measuring Systems Service after exceptionally heavy use or subjection
to unusual conditions or stress, before important work or at least once a year.
Testing and inspection by Hilti Measuring Systems Service does not relieve the user of the obligation to
check the scanning tool before and during use.
7 Transport and storage
Transport
▶ Prior to each use and before and after prolonged transport, check the product for damage.
Storage
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Never leave the product or batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product for damage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Malfunction
The product cannot be
switched on.
Individual laser beams don't
function.
Product can be switched on
but no laser beam is visible.
Automatic leveling doesn't
work.
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 Further information
Accessories, system products and more information about your product can all be found here.
*2341493*
Possible cause
Battery is empty
Battery polarity incorrect
Battery compartment is not closed
Product or on/off switch is faulty
Laser source or laser control unit is
faulty
Laser source or laser control unit is
faulty
Temperature is too high or too low
Product set up on an excessively
inclined surface
Pendulum is locked
2341493
Action to be taken
▶ Replace the batteries.
▶ Insert the batteries correctly.
▶ Close the battery compartment.
▶ Contact Hilti Service.
▶ Contact Hilti Service.
▶ Contact Hilti Service.
▶ Allow the product to cool down
or warm up.
▶ Set the product on a flat,
horizontal surface.
▶ Release the pendulum.
English 19