Stihl RMI 422 PC-LF Manual De Instrucciones página 24

English
To connect the power supply to the docking station:
WARNING
To reduce the risk of electric shock, make sure the power
supply is not plugged into the electrical socket when
handling the connector and inserting it into the docking
station. Always unplug the power supply from the electrical
socket before removing the cover of the docking station.
5
► Remove the docking station cover (5) by lifting it over the
tabs on each side.
6
► Fold the panel (6) forward and hold it in the open position.
► Insert the connector (7) to the left port (8) on the circuit
board of the panel as illustrated.
22
► Guide the power supply cord through the strain relief (9),
through the cable duct (10) and out the rear of the docking
5
station.
NOTICE
Make sure the connector and port on the circuit board are
clean before connecting them.
The power supply is rated for outdoor use. For longer
service life, STIHL recommends protecting the power supply
from direct sunlight and damp or wet conditions.
To mount the power supply:
1
7
8
a
► Install the power supply outside the mowing area at least
one foot above the ground and never at ground level or in
any location where it could be immersed in water or other
liquids.
10 Installing the Robotic Mower
9
10
2
b
c
10
10
0478-131-3050-A