Programming The Robotic Mower: The Mowing Plan - Stihl RMI 422 PC-LF Manual De Instrucciones

English
– The robotic mower docks and undocks properly.
The robotic mower tracks its location using the built-in GPS
receiver. The coordinates of the perimeter wire are captured
during installation and each time the "iMow follows edge"
function is performed.
The display will show the distance covered as the robotic
mower travels around the perimeter of the mowing area.
► If you want to set specific starting points along the
perimeter wire, take note of the distance indicated on the
display at the desired location. For more information on
starting points, see @ 15.6.
► Remove all obstacles from the perimeter and adjust the
perimeter wire as necessary to ensure problem-free
operation.
To continue the test run after an interruption:
► Place the robotic mower on the perimeter wire or place it
within the mowing area facing the perimeter wire.
► Select Yes and press the OK button on the control panel.
After completing the test run, the robotic mower will dock
and then repeat the test in the opposite direction. After
completing the second test run, the robotic mower will dock
again and the next step of the installation assistant will be
called up. A successful perimeter wire test must be
completed for iMow to work properly.
NOTICE
STIHL recommends completing the full test run in both
directions.
32
10.8 Programming the Robotic Mower: the Mowing
Plan
WARNING
The robotic mower can be programmed to cut autonomously
during specific blocks of time (active times). When utilizing
this feature, keep bystanders, especially children, and pets
out of the mowing area. Never allow the robotic mower to
operate if you know that animals or persons are or may be
in the mowing area or vicinity, @ 5.6.3.
WARNING
Observe all applicable laws, regulations, standards and
ordinances when programming active times. Set and adjust
active times after completing the initial installation, @ 14.6.
2000 ft²
2500 ft²
3000 ft²
► Select the size of your lawn and confirm it by pressing the
OK button on the control panel.
Restricted areas and secondary areas must not be
included when calculating the size of the mowing area.
The robotic mower automatically calculates a mowing plan
based on the size of the lawn and the length of the perimeter
wire.
When the robotic mower has finished calculating the mowing
plan, the display shows the message "Confirm each day
individually or change active time."
► To end the calculation of the mowing plan, push the STOP
button.
10 Installing the Robotic Mower
0478-131-3050-A