1
2
Original Output Area
NOTE
•
When you are enlarging an A4 or A5 original onto A3 paper, place the original
horizontally.
•
The scanned originals are output to the original output area in the order that they are fed
into the feeder.
•
You can place different size originals together into the feeder if you set the Different Size
Originals mode. (See Chapter 2, "Advanced Operations," in the Copying Guide.)
Adjust the slide guides to fit the
size of your originals.
Neatly place your originals with
the side to be copied face up into
the original supply tray.
Place your originals as far into the feeder as
they will go.
IMPORTANT
•
Do not add or remove originals while
they are being scanned.
•
When scanning is complete, remove the
originals from the original output area to
avoid paper jams.
Placing Originals
2
2-11