Publicidad
Step 5
Separate the EXTENSION SLIDES (X) from the EXTENSION RAILS (W) as
å
shown in the upper diagram below. Be prepared, the parts are greasy.
Fasten four EXTENSION RAILS (W) to the INNER ENDS (C3 and D3). Use
å
eight GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in
å
the enlarged diagram. Then, slide the inner cartridge of the EXTENSION
RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
W
Open end
Page 10
X
Push the black lever in and pull the SLIDE from the RAIL.
After fastening the EXTENSION RAIL to the INNER END (C3),
the SAFETY STOP should touch the top edge of the RAILS. If
the gap is larger than 1/16" the drawers could lock up and not
open. If this happens, open two drawers at the same time to
override the interlock system. Remove the drawers to re-adjust
the INTERLOCK TRACK assembly.
3S
D3
W
W
Open end
W
C3
412015
Open end
W
www.sauder.com/services
Publicidad
