Publicidad
Step 9
Fasten the OUTER RIGHT END (A) to the RIGHT
å
MOLDING (R). Tighten two TWIST-LOCK® FASTENERS.
Insert two METAL PINS (1R) into the INNER RIGHT END (C3).
å
Fasten the INNER RIGHT END (C3) to the TOP (E2).
å
Tighten two TWIST-LOCK® FASTENERS.
NOTE: Be sure the METAL PINS in the INNER RIGHT END
å
insert into the holes in the TOP.
The surfaces with theTWIST-LOCK
FASTENERS should be facing inside.
Page 14
®
E2
A
412015
R
C3
1R
www.sauder.com/services
Publicidad
