Publicidad
Step 6
Tap two MOLDING CONNECTORS (17F) into the notches
å
in the MOLDINGS (O, R, and S).
Fasten the MOLDINGS (O, R, and S) to the TOP (E2). Use
å
eight SILVER 1-1/8" FLAT HEAD SCREWS (10S).
NOTE: Do not overtighten the SCREWS into the TOP.
å
Flat end
Finished surface
Rounded edge
www.sauder.com/services
17F
S
R
O
O
SILVER 1-1/8" FLAT HEAD SCREW
(8 used in this step)
E2
412015
Use your hammer to tap the
MOLDING CONNECTORS (17F)
into the notches in the MOLDINGS.
Flat end
17F
10S
S
R
Page 11
Publicidad
