Publicidad
Step 7
Fasten the OUTER LEFT END (B) to the LEFT MOLDING (S).
å
Tighten two TWIST-LOCK® FASTENERS.
S u
T W
F A
Page 12
B
h
w i t
®
C K
c e
r f a
- L O
S
I S T
E R
E N
S T
How to use the SAUDER TWIST-LOCK® FASTENER
1. Insert the dowel end of the FASTENER into the
hole of the adjoining part.
NOTE: The dowel end of the FASTENER must
remain fully inserted in the hole of the adjoining
part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips
screwdriver as tight as possible.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
S
Dowel end
412015
O
www.sauder.com/services
Publicidad
