Cherubini WAVE LOCK RX Instrucciones página 40

The additional middle position is useful to open the awning automatically through the
WindTec Lux sensor and to bring it to a middle position when the light of the environment
exceeds the threshold set. This additional middle position can be used only in combination
with the light automatism of the WindTec Lux sensor.
The awning cannot be brought to this position with the remote control.
However, there is the possibility to program the current middle position using the B button
(2 sec) command (see pag. 35).
If the additional middle position is not memorized, the light automatism of the WindTec
Lux sensor (when enabled) opens the awning completely. When the WindTec Lux (Set
button) sensor is tested, the movements of the motor do not take the additional middle
position into consideration: the awning always stops in the half-way position and opens
completely if the light exceeds the threshold value.
SETTING THE ADDITIONAL MIDDLE POSITION
After saving the limit switches, carry out the following command sequence:
Tn: Already programmed remote control
+
B C
Tn
Starting from this moment, the motor moves in the "DEAD MAN" mode. This makes it
possible to regulate the additional middle position in a precise way.
Carry out the following operations:
• Bring the awning to the desired open position.
• Press the B button of the remote control for about 2 seconds, until the motor gives a
confirmation signal.
up
down
Starting from this moment, when the WindTec Lux commands the opening of the awning
through the light automatism (if this is enabled), the awning will be brought to the
additional middle position.
SPECIAL FUNCTIONS
ADDITIONAL MIDDLE POSITION
B
Tn
B
Tn (2 sec)
B
40
Tn (2 sec)