Cherubini WAVE LOCK RX Instrucciones página 42

SETTING THE MIDDLE POSITION WITH COUPLING
After having memorised the limit switch, perform the command sequence:
Tn: Already programmed remote control
+
B C
Tn
From this moment onwards, the motor moves in "DEAD MAN"mode.
Close up the awning until it reaches its closed position (in box awnings, you will have
to keep the button pressed until the motor stops automatically at the limit stop).
Proceed with the sequence below:
• Put the Pergola at its "lowest coupling limit" position (fig. 1).
• Press button B (stop) for about 2 seconds, until the motor lifts the fabric into its
coupling position (fig. 2).
• Press button C key (down) to put the fabric on position "lowest uncoupling limit"
(fig. 3).
• Press the B button (stop) for about 2 seconds, until the motor lifts the fabric and ends
the uncoupling movement (fig. 4).
• From now to move the motor, just press either the up or down buttons briefly.
1
Fig. 1
2
C
Fig. 3
1
2
C
B
1
Fig. 2
2
3
B
1
3 2
Tn (2 sec)
Tn
3
Tn (2 sec)
Fig. 4
3
B
42
+
A C
Tn (2 sec)
1
Pergola closed
Lowest coupling
2
limit
Coupling
Lowest uncoupling
3
limit