Cherubini WAVE LOCK RX Instrucciones página 43

MIDDLE POSITION COMMAND WITH COUPLING
This optional function enables the awning to open to a middle position with coupling.
Once the middle position with coupling has been memorised, to bring the awning into
this position simply press button B (stop) for 2 seconds. When the middle position with
coupling is memorised, it will replace the standard middle position (Page 35). To memorise
the standard intermediate position (see page 35), first delete the middle position with
coupling.
DELETION OF MIDDLE POSITION WITH COUPLING
To delete the middle position with coupling, run the command sequence:
Tn: Already programmed remote control
+
B C
Tn
SHORT-TERM SETTING OF A REMOTE CONTROL
This function makes it possible to store a remote control temporarily, for example, with the
purpose of setting the limit switches during assembly in the factory. A later final saving
of the remote control will be possible using the appropriate command sequence (see:
"SETTING THE FIRST REMOTE CONTROL"). The operations described below can be carried
out only when the motor has just come out of the factory or after a full memory clearing
(see: "FULL MEMORY CLEARING"). The motor makes the following operations possible
only within the time limits described in order to make sure that the short-term setting is
used only in the installation or factory setting phase and not during daily use.
Power up the motor, make sure that no other motors having an empty memory are
powered up in the same operating range.
Within 30 seconds after start, press the B and C buttons simultaneously until the motor
gives a confirmation signal.
The remote control will remain stored for 5 minutes, while the motor is powered up.
After 5 minutes or when the motor has its power cut off, the remote control will be
cancelled.
T1: First remote control to be stored
B
B
B
Tn
+
C
+
C
T1
A
43
+
C
Tn (2 sec)