Aventics RTC 16 Instrucciones De Servicio página 23

AVENTICS | RTC/CKP | R402003540–BAL–001–AG | English
Querying the end position
With the RTC and CKP series, the end position query is
carried out by proximity sensors of the ST4 series.
RTC – Mounting ST4 sensors
From a piston size of 25 mm the RTS series is equipped
with two magnets; each magnet is positioned on the right
side of the slide, seen in the direction of movement of the
slide.
Ø ≥ 25 mm
Magnet position
RTC-BV and RTC-SB have sensor slots on both sides of the
cylinder body. RTC-CG and RTC-HD have one sensor slot
on the side with compressed air connections.
2
Mounting sensors, RTC series
1
M A = max. 0,3 Nm
1. Move the sensor (1) in the desired position in the
sensor slot.
The screw of the sensor must face upwards.
2. Tighten the screw in the sensor so that it locks into the
slot.
3. Pass out the cable sidewards in the cable recess (2) at
the bottom of the sensor slot and fix it.
CKP – Mounting ST4 sensors with sensor holder
Normally two sensor holders are delivered with each
cylinder version CKP and CKP-CL. They are used to attach
the magnetic sensors at the lateral sensor slots.
Sensors may be positioned anywhere along the length of
the cylinder. No more than two sensors can be placed in
each slot. If more than two sensors are required there is
no room for the cables in the slot. In that case make sure
that the cables are attached such that they are not
damaged by slide movements.
Mounting sensors, CKP series
1. Place the sensor (1) in the sensor holder (2) and
carefully tighten the screw in the sensor so that it locks
into the holder.
2. Place the holder with the sensor in the desired position
in the sensor slot and tighten the screw in the holder
so that it locks into the slot.
3. Pass out the cable sidewards in the cable recess at the
bottom of the sensor slot and fix it.
22